Advent ADV25 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Kfz-Elektronik Advent ADV25 herunter. Advent ADV25 Installation guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 15
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Installation Guide
ADV25
8.5" OVERHEAD LCD MONITOR
WITH DVD PLAYER
RR
Seitenansicht 0
1 2 3 4 5 6 ... 14 15

Inhaltsverzeichnis

Seite 1 - Installation Guide

Installation GuideADV258.5" OVERHEAD LCD MONITORWITH DVD PLAYERRR

Seite 2 - Important Note

8MOUNTING THE TRIM RINGRoofRoof SupportHeadlinerMounting BracketSelf-drilling ScrewsTrim RingVideo UnitM5 Screw

Seite 3 - TOOLS REQUIRED:

91) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect power harness to vehicle’s electrical system by tapping into an acces

Seite 4 - Installing The Snap On Covers

10ADV25Figure A * Antenna for Wireless FM Mod.** See Antenna Note on the previous pageANT.INRF OUTOUTFUSEDC INRed RCA (Audio Right)Clean the IR Re

Seite 5 - Snap On Cover (Shroud)

11CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of

Seite 6 - VEHICLE PREPARATION:

12Negative Switched Dome LightingRed / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory

Seite 7

© 2006 ADVENT, 150 Marcus Blvd. Hauppauge, NY 11788128-7641

Seite 8 - TRIM RING INSTALLATION:

An LCD panel and / or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is use

Seite 9

1MATERIALS INCLUDED IN THIS PACKAGE:1) ADV25 TV / Video Monitor with DVD – (1pc)2) 12 Pin Power / Signal harness (P/N 112-3483) – (1pc)3) 2 Pin Power

Seite 10 - MOUNTING THE TRIM RING

2Housingcatch catchInstalling The Snap On CoversBegin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will

Seite 11

31 2 3654Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press

Seite 12 - Figure A

4VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good gro

Seite 13 - Factory Dome light circuit

5GENERAL SYSTEM CONFIGURATIONS:The following is intended to provide some of the system configurations that are possible with the ADV25D

Seite 14 - Troubleshooting:

6Tape marker to screwdriver.Starting at your mark for thelowest point, trace the contour of the roofLowest point markCut lineHeadlinerTRIM RING INSTAL

Seite 15 - 128-7641

7TRIM RING INSTALLATION:Supplied screws as below use for install Trim Ring to unit. Please refer illustration below.A) #4 x 5/16 Self Tapping Screws (

Kommentare zu diesen Handbüchern

Keine Kommentare