Advent ADV38 Bedienungsanleitung

Installation GuideADV3810.2” OVERHEAD LCD MONITORWITH DVD PLAYERON OFF AUTO

CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of

Red / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory Door ajarswitch or BodyControl c

© 2011 ADVENT, 150 Marcus Blvd. Hauppauge, NY 11788128-8513C

Important NoticeAn LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is u

MATERIALS INCLUDED IN THIS PACKAGE:1) 10.2” TFT LCD Overhead Monitor With DVD Player - (1pc)2) 12 Pin Po

Begin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place.Place the pod on a soft surface t

Work on a soft surface to avoid damaging the plastic.Insert the supplied pry tool between the Housing and Snap On Cover (Shroud), then press the pry t

VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good grou

TRIM RING INSTALLATION:Note: This page only covers special installation considerations for thick trim ring installation. If the video monitor is to be

TRIM RING INSTALLATION:Supplied screws as below use for install Trim Ring to unit. Please refer illustration below.A) #4 x 5/16 Self Tapping Screws (1

91) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect the 2 pin power harness to vehicle’s electrical system by t